Frames | No Frames

Return to Stylus Studio EDIFACT home page.
Return to Stylus Studio EDIFACT D99B Code List page.

7273 -

Service requirement code
UN/CEFACT Revision 1999B Code List

Repr:an..3
Desc:Code specifying a service requirement.
This table also occurs in the following versions of this standard:
D00A, D00B, D01A, D01B, D01C, D02A, D02B, D03A, D03B, D04A, D04B, D93A, D94A, D94B, D95A, D95B, D96A, D96B, D97A, D97B, D98A, D98B, D99A, D99B

1Carrier loads
The cargo is loaded in the equipment by the carrier.
2Full loads
Container to be stuffed or stripped under responsibility and for account of the shipper or the consignee.
3Less than full loads
Container to be stuffed and stripped for account and risk of the carrier.
4Shipper loads
The cargo is loaded in the equipment by the shipper.
5To be delivered
The cargo is to be delivered as instructed.
6To be kept
The cargo is to be retained awaiting further instructions.
7Transhipment allowed
Transhipment of goods is allowed.
8Transhipment not allowed
Transhipment of goods is not allowed.
9Partial shipment allowed
Partial shipment is allowed.
10Partial shipment not allowed
Partial shipment is not allowed.
11Partial shipment and/or drawing allowed
Partial shipment and/or drawing is allowed.
12Partial shipment and/or drawing not allowed
Partial shipment and/or drawing is not allowed.
13Carrier unloads
The cargo is to be unloaded from the equipment by the carrier.
14Shipper unloads
The cargo is to be unloaded from the equipment by the shipper.
15Consignee unloads
The cargo is to be unloaded from the equipment by the consignee.
16Consignee loads
The cargo is to be loaded in the equipment by the consignee.
17Exclusive usage of equipment
Usage of the equipment is reserved for exclusive use.
18Non exclusive usage of equipment
Usage of the equipment is not reserved for exclusive use.
19Direct delivery
Consignment for direct delivery to the consignee.
20Direct pick-up
Consignment for direct pick-up from the consignee.
21Request for delivery advice services
The service provider is requested to advise about delivery.
22Do not arrange customs clearance
Indication that the recipient of the message is not to arrange customs clearance.
23Arrange customs clearance
Indication that the recipient of the message is to arrange customs clearance.
24Check container condition
Condition of the container is to be checked.
25Damaged containers allowed
Damaged containers are allowed.
26Dirty containers allowed
Dirty containers are allowed.
27Fork lift holes not required
Container needs not to be equipped with pocket holes, but they are allowed.
28Fork lift holes required
Container must be equipped with pocket holes.
29Insure goods during transport
Indication that the recipient of the message is to insure the goods during transport.
30Arrange main-carriage
Indication that the recipient of the message is to arrange the main-carriage.
31Arrange on-carriage
Indication that the recipient of the message is to arrange the on-carriage.
32Arrange pre-carriage
Indication that the recipient of the message is to arrange the pre-carriage.
33Report container safety convention information
Indication that the information on the Container Safety Convention plate (CSC-plate) should be reported.
34Check seals
Sealing up of the container is to be checked.
35Container must be clean
Container is to be released or delivered clean.
36Request for proof of delivery
The service provider is requested to provide proof of delivery.
37Request for Customs procedure
The service provider is requested to perform Customs procedure.
38Request for administration services
The service provider is requested to perform administration services.
39Transport insulated under Intercontainer INTERFRIGO conditions
Insulated transport under Intercontainer INTERFRIGO (joint European railways agreement) conditions.
40Transport mechanically refrigerated under Intercontainer INTERFRIGO conditions
Mechanically refrigerated transport under Intercontainer INTERFRIGO (joint European railways agreement) conditions.
41Cool or freeze service, not under Intercontainer INTERFRIGO conditions
Cool or freeze service not under Intercontainer INTERFRIGO (joint European railways agreement) conditions.
42Transhipment overseas
Transport equipment is to be transferred overseas.
43
Station delivery
The specified equipment destination station is also the place of delivery of the goods.
44
Non station delivery
The specified equipment destination station is not the place of delivery of the goods.

Change indicators
plus sign An addition.
asterisk Addition/substraction/change to a code entry for a particular data element.
hash or pound sign Changes to names.
vertical bar Changes to text for descriptions, notes and functions.
minus sign A deletion.
letter X Marked for deletion.

Usage indicators
Used in batch messages only.
Common usage in both batch and interactive messages.
Used in interactive messages only.

Return to Stylus Studio EDIFACT D99B Code List page.
EDI to XML Mapping for EDIFACT/X12 Convert EDIFACT/X12 Schemas to XML Schema Legacy Data Conversion Tools Access Relational Data as XML Visual XSLT and XQuery Mapping Tools EDIFACT to XML
Return to Stylus Studio EDIFACT home page.

Return to Stylus Studio home page.
Site Map | Privacy Policy | Terms of Use | Trademarks
Stylus Scoop XML Newsletter:
W3C Member
Stylus Studio® and DataDirect XQuery ™are from DataDirect Technologies, is a registered trademark of Progress Software Corporation, in the U.S. and other countries. © 2004-2016 All Rights Reserved.